神龙-Ⅲ直线感应加速器高稳定度恒流源控制系统

赵娟; 曹宁翔; 黄斌; 李波; 张信; 黄宇鹏; 李洪涛

doi:10.11884/HPLPB201931.190061

神龙-Ⅲ直线感应加速器高稳定度恒流源控制系统

doi: 10.11884/HPLPB201931.190061

中国工程物理研究院流体物理研究所, 四川绵阳 621900

基金项目:

中国工程物理研究院院长基金项目 YZJJLX2016002

详细信息

作者简介:
赵娟(1968—)，女，高级工程师，从事电源技术研究; zj680525@21cn.com

通讯作者:
李洪涛(1968—)，男，研究员，从事脉冲功率技术研究; lihongtao-ifp@caep.cn

中图分类号: TN86
计量
- 文章访问数: 1396
- HTML全文浏览量: 317
- PDF下载量: 118
- 被引次数: 0
出版历程
- 收稿日期: 2019-01-22
- 修回日期: 2019-03-12
- 刊出日期: 2019-04-15

Control system of Dragon-Ⅲ linear induction accelerator's high stability constant current source

Institute of Fluid Physics, CAEP, P.O.Box 919-113, Mianyang 621900, China

摘要

摘要: 大功率恒流源是强流直线感应加速器(LIA)的关键设备之一，用于为加速器电感线圈提供大功率准直流驱动电流，其稳定度、纹波系数等指标要求极高。神龙-Ⅲ LIA恒流源采用串联线性双闭环回路双参量电流调控技术，同时综合应用了以PLC控制器为核心的本地控制、以ARM控制器和工控机为核心的远程控制以及以太网网络通讯技术，实现了强电磁干扰环境下远程控制高稳定性运行。该恒流源在负载0.5~0.6 Ω之间变化、输出电流在50~170 A之间变化时调整管压降控制在8 V±2 V范围内，输出电流纹波和电流稳定度均优于0.5‰。
- 恒流电源 /
- 双参量取样 /
- 双回路闭环控制 /
- 线性调制 /
- 远程控制
Abstract: The high power constant current source is one of the key equipments of the high current linear induction accelerator (LIA) which outputs high power direct current to power the inductor. The requirement of the parameters such as instability, ripple coefficient is very strict. The serial linear dual-loop dual-parameters feedback control technical was applied in the design of the constant current source of Dragon-Ⅲ LIA to adjust the output current. In this device, the local control system based on the PLC controller, the remote control system based on the ARM controller and computer, and the communication system based on the Ethernet were comprehensively applied in the design of the control system, which made its stability very high as it operated under remote control model in high electromagnetic interference circumstance. As the resistance of the load change among 0.5-0.6 Ω and the current change among 50-170 A, the voltage drop of the transistor was restricted at 8 V±2 V, and the ripple coefficient and the drift of the current were less than 0.5‰.
- constant current source /
- dual parameters sample /
- dual loop feedback control /
- linear modulation /
- remote control

HTML全文

图 1 恒流源原理图

Figure 1. Schematic diagram of constant current source

下载: 全尺寸图片幻灯片

图 2 恒流源控制工作框图

Figure 2. Schematic diagram of control system of the constant current source

下载: 全尺寸图片幻灯片

图 3 恒流源远程控制系统结构框图

Figure 3. Schematic diagram of remote control system

下载: 全尺寸图片幻灯片

图 4 恒流源电流纹波波形

Figure 4. Waveform of output current ripple (I=50 A, R_L=0.6 Ω)

下载: 全尺寸图片幻灯片

参考文献(11)

[1]	丁伯南, 邓建军, 王华岑, 等. "神龙一号"直线感应电子加速器[J]. 高能物理与核物理, 2005, 29(6): 604-610. https://www.cnki.com.cn/Article/CJFDTOTAL-KNWL200506014.htm Ding Bonan, Deng Jianjun, Wang Huachen, et al. Dragon- 1 linear induction electron accelerator. High Energy Physics and Nuclear Physics, 2005, 29(6): 604-610 https://www.cnki.com.cn/Article/CJFDTOTAL-KNWL200506014.htm
[2]	邓建军. 直线感应电子加速器[M]. 北京: 国防工业出版社, 2006: 100-106. Deng Jianjun. Linear induction electron accelerator. Beijing: National Defence Industry Press, 2006: 100-106
[3]	石金水, 邓建军, 章林文, 等. 神龙二号加速器及其关键技术[J]. 强激光与粒子束, 2016, 28: 010201. doi: 10.11884/HPLPB201628.010201 Shi Jinshui, Deng Jianjun, Zhang Linwen, et al. Dragon-Ⅱ accelerator and its key technology. High Power Laser and Particle Beams, 2016, 28: 010201 doi: 10.11884/HPLPB201628.010201
[4]	杨琼松. 10 MeV LIA大功率高稳定恒流电源的研制[C]//10 MeV直线感应加速器文集. 1994: 146-155. Yang Qiongsong. Research of constant current source with high power and high stability. Proceedings of the Conference on 10 MeV LIA. 1994: 146-152
[5]	代志勇, 章林文, 邓建军, 等. "神龙-Ⅰ"直线感应加速器束流输运系统设计[J]. 强激光与粒子束, 2001, 13(6): 78I-784. http://www.hplpb.com.cn/article/id/1712 Dai Zhiyong, Zhang Linwen, Deng Jianjun, et al. Design of the beam transport system for SL-I LIA. High Power Laser and Particle Beams, 2001, 13(6): 781-784 http://www.hplpb.com.cn/article/id/1712
[6]	赵娟, 曹科峰, 曹宁翔, 等. HL80型低纹波系数大电流程控恒流源研制[J]. 强激光与粒子束, 2010, 22(4): 807-811. http://www.hplpb.com.cn/article/id/4497 Zhao Juan, Cao Kefeng, Cao Ningxiang, et al. Development of HL80 Low ripple high current computer-controlling constant current source. High Power Laser and Particle Beams, 2010, 22(4): 807-811 http://www.hplpb.com.cn/article/id/4497
[7]	赵娟, 李波, 于治国, 等. 大功率恒流源取样电阻设计[J]. 强激光与粒子束, 2012, 24(4): 925-928. doi: 10.3788/HPLPB20122404.0925 Zhao Juan, Li Bo, Yu Zhiguo, et al. Design of sampling resistor in high power constant-current source. High Power Laser and Particle Beams, 2012, 24(4): 925-928 doi: 10.3788/HPLPB20122404.0925
[8]	丁卫东, 张乔根, 邱敏昌, 等. 高电压恒流源的应用及发展[J]. 高电压技术, 1999, 25(4): 64-68. https://www.cnki.com.cn/Article/CJFDTOTAL-GDYJ199904025.htm Ding Weidong, Zhang Qiaogen, Qiu Minchang, et al. The Application and development of high voltage constant-current power supply. High Voltage Engineering, 1999, 25(4): 64-68 https://www.cnki.com.cn/Article/CJFDTOTAL-GDYJ199904025.htm
[9]	赵娟, 李波, 李玺钦, 等. 高电磁兼容性大功率恒流源设计与实现[J]. 强激光与粒子束, 2018, 30: 025007. doi: 10.11884/HPLPB201830.170359 Zhao Juan, Li Bo, Li Xiqin, et al. Design and actualization of the high electromagnetic compatibility for high power constant-current supply. High Power Laser and Particle Beams, 2018, 30: 025007 doi: 10.11884/HPLPB201830.170359
[10]	薛易. 高精度程控恒流源设计[J]. 自动化仪表, 2009, 30(4): 63-65. https://www.cnki.com.cn/Article/CJFDTOTAL-KJXX201311204.htm Xue Yi. Design of a high precision program-controlled constant-current source. Process Automation Instrumentation, 2009, 30(4): 63-65 https://www.cnki.com.cn/Article/CJFDTOTAL-KJXX201311204.htm
[11]	卫兵, 卿燕玲, 王敏华, 等. 一种脉冲高电压测量探头的地电位隔离方法[J]. 强激光与粒子束, 2011, 23(8): 2234-2238. http://www.hplpb.com.cn/article/id/5356 Wei Bing, Qing Yanling, Wang Minhua, et al. Ground isolation with common mode inductance for high voltage pulse measurement. High Power Laser and Particle Beams, 2011, 23(8): 2234-2238 http://www.hplpb.com.cn/article/id/5356