Sealed X-ray framing tube with CsI photocathode to achieve high detection efficiency and stability
-
摘要: 为解决采用Au光电阴极、开放式结构的分幅变像管探测效率低、稳定性差的问题,研制了一种采用CsI光电阴极的密封式分幅变像管。为了对比不同光电阴极对X射线的响应强度,密封式分幅变像管制作有一条Au微带阴极和一条CsI微带阴极。完成了密封式分幅变像管的结构设计、工艺制作和实验测试。研究结果表明:当加载半高宽度200 ps、幅值−2.7 kV的选通脉冲时测得其时间分辨为65 ps;在非单色高能X射线源照射下,CsI阴极的静态响应强度是Au阴极的3.4倍;大气环境中存储1000 h后密封式分幅变像管的静态响应强度仅降低到完成制作时的83%。上述结果表明采用CsI阴极的密封式分幅变像管具有更高的探测效率和稳定性,可有效提升X射线分幅成像质量和可靠性。Abstract: A hermetically sealed X-ray framing tube with CsI photocathode is proposed to solve the problems of poor stability and low detection quantum efficiency brought by the open structure framing tube with Au photocathodes. Two microstrip photocathodes of 100 nm Au and 100 nm CsI are fabricated to compare their sensitivities under the same environmental conditions. The structure and the fabrication process of the sealed framing tube are described inthispaper. After fabrication, the sealed framing tube is tested to verify its performance. The measurement shows that exposure time of the proposed framing tube is 65 ps when gated by an ultrafast pulse with 200 ps width and −2.7 kV amplitude. At static mode, the image intensity of the CsI photocathode is 3.4 times that of the Au photocathode under the irradiation of non-monochromatic high energy X-ray source. Its static response intensity is reduced to 83% compared with the initial value after being stored in the laboratory air for 1000 h. These results indicate that the sealed framing tube with CsI photocathode can achieve higher detection efficiency and stability, and can effectively improve the quality and reliability of X-ray framing imaging.
-
Key words:
- framing camera /
- X-ray detector /
- ultra-fast diagnostics /
- fusion diagnosis /
- CsI photocathode
-
图 10 (a)CsI阴极密封式分幅变像管静态响应强度随存储时间的变化关系和(b)Au阴极开放式分幅变像管静态响应强度随累计大气暴露时间的变化关系
Figure 10. (a) Normalized intensity of sealed X-ray framing tube with CsI photocathode as a function of storage time and (b) normalized intensity of open-structured X-ray framing tube with Au photocathode as a function of accumulated air exposure time
-
[1] Bradley D K, Bell P M, Kilkenny J D, et al. High-speed gated X-ray imaging for ICF target experiments[J]. Review of Scientific Instruments, 1992, 63(10): 4813-4817. doi: 10.1063/1.1143571 [2] Chang Zenghu, Shan Bing, Liu Xiuqin, et al. Gated MCP framing camera with 60-ps exposure time[C]//Proceedings of SPIE 2549, Ultrahigh-and High-Speed Photography, Videography, and Photonics'95. 1995: 53-59. [3] Yang Wenzheng, Bai Yonglin, Liu Baiyu, et al. Temporal resolution technology of a soft X-ray picosecond framing camera based on Chevron micro-channel plates gated in cascade[J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2009, 608(2): 291-296. [4] Oertel J A, Aragonez R, Archuleta T, et al. Gated X-ray detector for the National Ignition Facility[J]. Review of Scientific Instruments, 2006, 77: 10E308. doi: 10.1063/1.2227439 [5] 曹柱荣, 王强强, 邓博, 等. 激光聚变极端环境下X光高速摄影技术研究进展[J]. 强激光与粒子束, 2020, 32(11):112004. (Cao Zhurong, Wang Qiangqiang, Deng Bo, et al. Progress of X-ray high-speed photography technology used in laser driven inertial confinement fusion[J]. High Power Laser and Particle Beams, 2020, 32(11): 112004 [6] 王峰, 张兴, 理玉龙, 等. 激光惯性约束聚变研究中高时空诊断技术研究进展[J]. 强激光与粒子束, 2020, 32(11):112002. (Wang Feng, Zhang Xing, Li Yulong, et al. Progress in high time- and space-resolving diagnostic technique for laser-driven inertial confinement fusion[J]. High Power Laser and Particle Beams, 2020, 32(11): 112002 [7] Pawley C J, Deniz A V. Improved measurements of noise and resolution of X-ray framing cameras at 1−2 keV[J]. Review of Scientific Instruments, 2000, 71(3): 1286-1295. doi: 10.1063/1.1150497 [8] Henke B L, Liesegang J, Smith S D. Soft-X-ray-induced secondary-electron emission from semiconductors and insulators: Models and measurements[J]. Physical Review B, 1979, 19(6): 3004-3021. doi: 10.1103/PhysRevB.19.3004 [9] 黎宇坤, 陈韬, 李晋, 等. CsI光阴极在10—100 keV X射线能区的响应灵敏度计算[J]. 物理学报, 2018, 67:085203. (Li Yukun, Chen Tao, Li Jin, et al. Calculation of CsI photocathode spectral response in 10-100 keV X-ray energy region[J]. Acta Physica Sinica, 2018, 67: 085203 doi: 10.7498/aps.67.20180029 [10] Xie Yuguang, Zhang Aiwu, Liu Yingbiao, et al. Influence of air exposure on CsI photocathodes[J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2012, 689: 79-86. [11] Chollet M, Ahr B, Walko D A, et al. Hard X-ray streak camera at the advanced photon source[J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2011, 649(1): 70-72. [12] Opachich Y P, Kalantar D H, MacPhee A G, et al. High performance imaging streak camera for the National Ignition Facility[J]. Review of Scientific Instruments, 2012, 83: 125105. doi: 10.1063/1.4769753 [13] Henke B L, Knauer J P, Premaratne K. The characterization of X-ray photocathodes in the 0.1−10-keV photon energy region[J]. Journal of Applied Physics, 1981, 52(3): 1509-1520. doi: 10.1063/1.329789 [14] Boone J M, Seibert J A. An accurate method for computer-generating tungsten anode X-ray spectra from 30 to 140 kV[J]. Medical Physics, 1997, 24(11): 1661-1670. doi: 10.1118/1.597953 [15] Tommasini R, Hatchett S P, Hey D S, et al. Development of Compton radiography of inertial confinement fusion implosions[J]. Physics of Plasmas, 2011, 18: 056309. doi: 10.1063/1.3567499 [16] Nagel S R, Trosseille C A, MacPhee A, et al. Evaluation of X-ray transmission photocathode detection issues in the energy range of 8-30 keV[C]//Proceedings of SPIE 11114, Hard X-Ray, Gamma-Ray, and Neutron Detector Physics XXI. 2019: 1111416. [17] Li Yaran, Mu Baozhong, Xie Qing, et al. Development of an X-ray eight-image Kirkpatrick–Baez diagnostic system for China’s laser fusion facility[J]. Applied Optics, 2017, 56(12): 3311-3318. doi: 10.1364/AO.56.003311