一种多通道高速数据采集系统软件

周文渊; 呼义翔; 尹佳辉; 罗维熙; 张信军

doi:10.11884/HPLPB202234.210520

一种多通道高速数据采集系统软件

doi: 10.11884/HPLPB202234.210520

西北核技术研究所强脉冲辐射环境模拟及效应国家重点实验室，西安 710024

基金项目: 国家自然科学基金面上项目（51577156）

详细信息

作者简介:
周文渊，hellozwy@163.com

中图分类号: TP216
计量
- 文章访问数: 885
- HTML全文浏览量: 227
- PDF下载量: 70
- 被引次数: 0
出版历程
- 收稿日期: 2021-11-25
- 修回日期: 2022-05-21
- 网络出版日期: 2022-05-26
- 刊出日期: 2022-06-17

A multi-channel high speed data acquisition system software

State Key Laboratory of Intense Pulsed Radiation Simulation and Effect, Northwest Institute of Nuclear Technology, P. O. Box 69-10, Xi’an 710024, China

摘要

摘要: 多通道高速数据采集软件面临：被测信号多样化，通道设置及管理难度大；传输数据并发量大，传输稳定性和瞬时传输速度要求高；测量数据量大，后处理及速度快；实验数据重要性高，测试软件必须稳定可靠的挑战。软件采用模块化+图形化设计，使用SCPI命令对设备及通道进行设置；测试了75台示波器同时上传数据的传输速度；对比了LabVIEW波形显示和GDI+波形绘制的区别；完成了上位机故障情况下数据获取功能设计。结果表明：该数据采集软件可完成75台示波器的管理，实现300通道数据的上传、处理、显示、存储。100 kpts存储深度300通道数据上传时间为9.7 s，300通道波形刷新时间为0.91 s。
- 多通道高速数据 /
- 数据采集 /
- 数据传输 /
- 波形显示 /
- 波形刷新时间
Abstract: Multichannel high-speed data acquisition software is facing the following difficulties: complexity in setup and management of signal multichannel; The concurrent transmission of data requires high stability and instantaneous transmission speed; High-speed post-processing and high-speed waveform display are required for large amount of measurement data; The test software must be stable and reliable to meet the important requirements of experimental data. The software uses modular graphical design and SCPI to complete channel setup. The transmission speed of data uploaded simultaneously by 75 oscilloscopes was tested. The differences between LabView waveform display and GDI+ waveform drawing are compared. Data acquisition function in case of software failure is designed. It is shown that the data acquisition software can manage 75 oscilloscopes and upload, process, display and store 300 channels of data. 100 kpts memory 300 channel data upload time is 9.7s, 300 channel waveform refresh time is 0.91 s.
- multichannel high-speed data acquisition /
- data acquisition /
- data transmission /
- data waveform display /
- waveform refresh time

HTML全文

图 1 软件框图

Figure 1. Software block diagram

下载: 全尺寸图片幻灯片

图 2 数据采集流程图

Figure 2. Data acquisition flow chart

下载: 全尺寸图片幻灯片

图 3 仪器配置界面

Figure 3. Instrument configuration page

下载: 全尺寸图片幻灯片

图 4 通道配置界面

Figure 4. Channel configuration page

下载: 全尺寸图片幻灯片

图 5 显示配置界面

Figure 5. Display configuration window

下载: 全尺寸图片幻灯片

图 6 记录配置界面

Figure 6. Record configuration window

下载: 全尺寸图片幻灯片

图 7 波形监测界面

Figure 7. Waveform monitor window

下载: 全尺寸图片幻灯片

图 8 运行监测界面

Figure 8. Status monitor window

下载: 全尺寸图片幻灯片

图 9 数据调取界面

Figure 9. Data loader window

下载: 全尺寸图片幻灯片

图 10 波形显示界面

Figure 10. Waveform window

下载: 全尺寸图片幻灯片

图 11 数据库表结构

Figure 11. SQL structure table

下载: 全尺寸图片幻灯片

参考文献(15)

[1]	刘锡三. 高功率脉冲技术[M]. 北京: 国防工业出版社, 2005: 15 Liu Xisan. High pulsed power technology[M]. Beijing: National Defense Industry Press, 2005: 15
[2]	丛培天. 中国脉冲功率科技进展简述[J]. 强激光与粒子束, 2020, 32:025002. (Cong Peitian. Review of Chinese pulsed power science and technology[J]. High Power Laser and Particle Beams, 2020, 32: 025002 Cong Peitian. Review of Chinese pulsed power science and technology[J]. High Power Laser and Particle Beams, 2020, 32: 025002
[3]	张振, 卜雄洙, 邵奎. 基于串行通信的示波器控制平台设计[J]. 仪表技术, 2013, 32(5):4-7. (Zhang Zhen, Bu Xiongzhu, Shao Kui. Design of oscilloscope control platform based on serial communication[J]. Instrumentation Technology, 2013, 32(5): 4-7 Zhang Zhen, Bu Xiongzhu, Shao Kui. Design of oscilloscope control platform based on serial communication[J]. Instrumentation Technology, 2013, 32(5): 4-7
[4]	王福亮, 韩雷, 钟掘. GDS-820数字存储示波器控制软件的开发[J]. 中南大学学报(自然科学版), 2005, 36(2):262-266. (Wang Fuliang, Han Lei, Zhong Jue. Development of control software for GDS-820 digital storage oscilloscope[J]. Journal of Central South University (Science and Technology), 2005, 36(2): 262-266 doi: 10.3969/j.issn.1672-7207.2005.02.019 Wang Fuliang, Han Lei, Zhong Jue. Development of control software for GDS-820 digital storage oscilloscope[J]. Journal of Central South University (Science and Technology), 2005, 36(2): 262-266 doi: 10.3969/j.issn.1672-7207.2005.02.019
[5]	李林潇, 江先阳. 基于LabVIEW的示波器控制与演示系统设计[J]. 物理实验, 2018, 38(s1):103-107. (Li Linxiao, Jiang Xianyang. Design of oscilloscope control and demonstration system based on LabVIEW[J]. Physics Experimentation, 2018, 38(s1): 103-107 Li Linxiao, Jiang Xianyang. Design of oscilloscope control and demonstration system based on LabVIEW[J]. Physics Experimentation, 2018, 38(s1): 103-107
[6]	胡凤明, 陆泽. 基于LabVIEW和GPIB的数字示波器数据自动采集系统设计[J]. 计算机测量与控制, 2016, 24(3):289-290,295. (Hu Fengming, Lu Ze. Design of digital oscilloscope acquisition system based on LabVIEW and GPIB[J]. Computer Measurement & Control, 2016, 24(3): 289-290,295 Hu Fengming, Lu Ze. Design of digital oscilloscope acquisition system based on LabVIEW and GPIB[J]. Computer Measurement & Control, 2016, 24(3): 289-290, 295
[7]	郭晓强, 林东生, 彭宏论, 等. 辐射效应测量中数字示波器控制软件的研制[J]. 抗核加固, 2005, 22(2):38-45. (Guo Xiaoqiang, Lin Dongsheng, Peng Honglun, et al. Development of digital oscilloscope control software in radiation effect measurement[J]. Kang He Jia Gu, 2005, 22(2): 38-45 Guo Xiaoqiang, Lin Dongsheng, Peng Honglun, et al. Development of digital oscilloscope control software in radiation effect measurement[J]. Kang He Jia Gu, 2005, 22(2): 38-45
[8]	马春雷. 基于GPIB的示波器校准仪自动化检定系统的设计与实现[J]. 宇航计测技术, 2008, 28(3):42-44,56. (Ma Chunlei. Design and realization of automatic test and calibrating system for oscilloscope calibrator based on GPIB[J]. Journal of Astronautic Metrology and Measurement, 2008, 28(3): 42-44,56 doi: 10.3969/j.issn.1000-7202.2008.03.010 Ma Chunlei. Design and realization of automatic test and calibrating system for oscilloscope calibrator based on GPIB[J]. Journal of Astronautic Metrology and Measurement, 2008, 28(3): 42-44, 56 doi: 10.3969/j.issn.1000-7202.2008.03.010
[9]	徐宙, 刘连照, 程彦杰, 等. 基于C#的数字存储示波器控制软件设计与实现[J]. 计量与测试技术, 2016, 43(2):53-55,57. (Xu Zhou, Liu Lianzhao, Cheng Yanjie, et al. Design and realization of control software for digital storage oscilloscope based on C#[J]. Metrology & Measurement Technique, 2016, 43(2): 53-55,57 Xu Zhou, Liu Lianzhao, Cheng Yanjie, et al. Design and realization of control software for digital storage oscilloscope based on C#[J]. Metrology & Measurement Technique, 2016, 43(2): 53-55, 57
[10]	Zhang Lixiao, Li Xin, Li Yanshuang. LabVIEW-based design and realization of virtual oscilloscope[M]//Jin D, Lin S. Advances in mechanical and electronic engineering. Berlin: Springer, 2012: 269-274.
[11]	杜芳. 基于LabVIEW的PXI虚拟数字示波器设计[D]. 哈尔滨: 哈尔滨工业大学, 2011 Du Fang. The design of PXI virtual digital oscilloscope based on LabVIEW[D]. Harbin: Harbin Institute of Technology, 2011
[12]	陈珠. 基于LAN方式的示波器仪器驱动及程控软件设计[D]. 成都: 电子科技大学, 2020 Chen Zhu. Design of oscilloscope instrument driver and program control software based on LAN[D]. Chengdu: University of Electronic Science and Technology of China, 2020
[13]	Coffey S K, Lewis B, Joseph N, et al. Hardware and software upgrades for the saturn data acquisition triggers and time base (work supported by the Dept. of Energy)[C]//2015 IEEE Pulsed Power Conference. 2015: 3390C.
[14]	Coffey S K, Lewis B, Sedillo J, et al. Trigger system changes for the HERMES III accelerator[C]//2017 IEEE 21st International Conference on Pulsed Power. 2017: 3390C.
[15]	田青, 李万昌, 卫兵, 等. 基于局域网的PTS数据采集、处理系统的研制[J]. 现代电子技术, 2012, 35(20):152-154,158. (Tian Qing, Li Wanchang, Wei Bing, et al. Development of PTS data acquisition and processing system based of LAN technology[J]. Modern Electronics Technique, 2012, 35(20): 152-154,158 doi: 10.3969/j.issn.1004-373X.2012.20.046 Tian Qing, Li Wanchang, Wei Bing, et al. Development of PTS data acquisition and processing system based of LAN technology[J]. Modern Electronics Technique, 2012, 35(20): 152-154, 158 doi: 10.3969/j.issn.1004-373X.2012.20.046