切削用量对铝靶表面质量的影响
Effect of cutting conditions on surface roughness of aluminum target
-
摘要: 采用单点金刚石切削技术，完成了对ICF实验用铝靶的切削加工，重点研究了切削用量对加工表面质量的影响。实验结果表明：采用较小的进给速度，较大的主轴转速能够获得较低的表面粗糙度，切削深度对表面质量影响较小。通过Form Talysurf 表面轮廓仪测量，结果表明表面粗糙度小于50 nm。Abstract: In this paper, the Al target in ICF experiment was produced by single point diamond turning technology. The effect of turning process on the surface roughness of Al target was discussed. The experiment results have demonstrated that lower surface roughness of Al target can be fabricated with smaller feed speed and higher spindle rotate speed. The surface roughness was analyzed by means of Form Talysurf device. The result showed that the surface roughness of the aluminum target was less than 50 nm.
-
点击查看大图
计量
- 文章访问数: 2264
- HTML全文浏览量: 237
- PDF下载量: 631
- 被引次数: 0
下载:
