Design of 0.34 THz bandpass filter based on frequency selective surface

Tian Yaoling; Jiang Jun; Lu Bin; Deng Xianjin

doi:10.11884/HPLPB201527.123101

Volume 27 Issue 12

Jan. 2016

Turn off MathJax

Article Contents

Article Navigation > High Power Laser and Particle Beams > 2015 > 27(12): 123101

Tian Yaoling, Jiang Jun, Lu Bin, et al. Design of 0.34 THz bandpass filter based on frequency selective surface[J]. High Power Laser and Particle Beams, 2015, 27: 123101. doi: 10.11884/HPLPB201527.123101

Citation:

Tian Yaoling, Jiang Jun, Lu Bin, et al. Design of 0.34 THz bandpass filter based on frequency selective surface[J]. High Power Laser and Particle Beams, 2015, 27: 123101. doi: 10.11884/HPLPB201527.123101

Citation:

PDF( 2189 KB)

Design of 0.34 THz bandpass filter based on frequency selective surface

doi: 10.11884/HPLPB201527.123101

Tian Yaoling^1,2,
Jiang Jun^1,2,
Lu Bin^1,2,
Deng Xianjin^{1,2
,
,}

1.
Institute of Electronic Engineering,CAEP,Mianyang 621900,China;
2.
Microsystem and Terahertz Research Center,China Academy of Engineering Physics,Chengdu 610200,China

Received Date: 2015-07-18
Rev Recd Date: 2015-09-23
Publish Date: 2015-11-26

Abstract

Abstract

In order to meet the requirement of THz communication, a 0.34 THz bandpass filter was designed based on thinfilm processing and double screen frequency selective surface(FSS). The frequency characteristics of the FSS filter were analyzed by using the equivalent circuit model and the influence of incident angles on the frequency response characteristics of the designed FSS filter was investigated by simulation. The results show that a better frequency response can be obtained at all the angles below 45 with TE polarization. Finally, a sample of the FSS filter was produced, tested and analyzed. The results indicate that this FSS filter has a good performance.
- terahertz,
- frequency selective surface,
- bandpass filter