Fabrication of high molar ratio K2O hollow glass microsphere for laser fusion research

du shou-de; li bo; shi tao; tang yong-jian

Volume 17 Issue 07

Jul. 2005

Turn off MathJax

Article Contents

Abstract

References

Article Navigation > High Power Laser and Particle Beams > 2005 > 17(07): 0-

zhang peng, yuan sheng-fu, wang hong-yan, et al. Fixed angle plane reflective mirrors scanning measurements for laser small signal gain[J]. High Power Laser and Particle Beams, 2005, 17.

Citation:

du shou-de, li bo, shi tao, et al. Fabrication of high molar ratio K2O hollow glass microsphere for laser fusion research[J]. High Power Laser and Particle Beams, 2005, 17.

zhang peng, yuan sheng-fu, wang hong-yan, et al. Fixed angle plane reflective mirrors scanning measurements for laser small signal gain[J]. High Power Laser and Particle Beams, 2005, 17.

Citation:

du shou-de, li bo, shi tao, et al. Fabrication of high molar ratio K2O hollow glass microsphere for laser fusion research[J]. High Power Laser and Particle Beams, 2005, 17.

PDF( 113 KB)

Fabrication of high molar ratio K2O hollow glass microsphere for laser fusion research

1.
Research Center of Laser Fusion,CAEP,P.O.Box 919-990,Mianyang 621900,China

Publish Date: 2005-07-15

Abstract

Abstract

With inorganic compounds, hollow glass microsphere (HGM) of above 10% molar ratio K2O was prepared by liquid-droplet method.The glass forming oxides content in solutions and technical conditions of preparing were optimized and selected. The molar ratios of glass forming oxides in shell of HGM were analyzed by means of EDAX device.The results showed that the diameter, wall thickness, concentricity and sphericity of HGM satisfied the physical experiments on the SG II device.Test value of molar ratio of glass forming oxides in HGM were closed to theoretic value.
- liquid-droplet method,
- high molar ratio k2o hollow glass microsphere,
- icf,
- molar ratio

FullText(HTML)

References(0)

References

Relative Articles

[1]	Guo Zhou, Zhang Hongqiang, Yang Zhen, Yan Feixue. Study on recovery pressure of diffuser for DF chemical laser[J]. High Power Laser and Particle Beams, 2025, 37(2): 021003. doi: 10.11884/HPLPB202537.240290
[2]	Li Jinxue, Ren Xiaoming, Guo Zhou, Qiu Xiongfei. Study of diffuser’s start up property in chemical lasers[J]. High Power Laser and Particle Beams, 2022, 34(3): 031008. doi: 10.11884/HPLPB202234.210273
[3]	Li Jinxue, Wang Jie, Yan Feixue, Wang Zhijie, Guo Jianzeng. Simulation and optimization of DF chemical lasers' diffuser[J]. High Power Laser and Particle Beams, 2018, 30(10): 101002. doi: 10.11884/HPLPB201830.180113
[4]	Jin Donghuan, Liu Wenguang, Chen Xing, Lu Qisheng, Zhao YiJun. 化学激光器1/4环柱型增益发生器[J]. High Power Laser and Particle Beams, 2012, 24(05): 1015-1018. doi: 10.3788/HPLPB20122405.1015
[5]	luo wei, yuan shengfu, zou qianjin, lu qisheng. Calculation of temperature and population distribution in DF laser cavity based on emission spectrum[J]. High Power Laser and Particle Beams, 2011, 23(06): 0- .
[6]	jin donghuan, liu wenguang, chen xing, lu qisheng, zhao yijun. Numerical study of flow field characteristics of Venturi nozzle for chemical laser[J]. High Power Laser and Particle Beams, 2011, 23(05): 0- .
[7]	luo wei, yuan shengfu, lu qisheng, yan baozhu. Chemiluminescence spectrum in optical cavity of discharge driven DF chemical laser[J]. High Power Laser and Particle Beams, 2011, 23(02): 0- .
[8]	jin donghuan, liu wenguang, chen xing, lu qisheng, zhao yijun. Experimental study on two-step reaction in combustor of chemical laser[J]. High Power Laser and Particle Beams, 2011, 23(08): 0- .
[9]	huang zhilong, zhang guobiao, geng zihai, chen jiming. Performance of line-divergence subsection supersonic diffuser for COIL[J]. High Power Laser and Particle Beams, 2011, 23(05): 0- .
[10]	yan baozhu, yuan shengfu, mao haifeng. Flow rate calibration on injectors of chemical laser[J]. High Power Laser and Particle Beams, 2011, 23(05): 0- .
[11]	yu jinbiao, chen xing, wang hongyan, zhang xuanzhe, li wenyu, hua weihong, si lei. Small signal gain measurement for supersonic nitrogen diluted continuous wave HF chemical laser[J]. High Power Laser and Particle Beams, 2011, 23(10): 0- .
[12]	yan baozhu, yuan shengfu, lu qisheng, hua weihong. Phase change of nitrogen as primary flow in gas channel model of directly drained CW DF/HF chemical laser[J]. High Power Laser and Particle Beams, 2010, 22(01): 0- .
[13]	yan baozhu, yuan shengfu, wang zhigang, lu qisheng. Experimental investigation on critical background-pressure ratio of Venturi for chemical laser[J]. High Power Laser and Particle Beams, 2009, 21(11): 0- .
[14]	li lan, hua weihong, yuan shengfu, jiang zongfu. Numerical investigation of TRIP mixing mechanism in CW DF/HF chemical laser[J]. High Power Laser and Particle Beams, 2009, 21(01): 0- .
[15]	li lan, yuan shengfu, hua weihong, jiang zongfu. Numerical investigation of jets’ influence on TRIP gain generator[J]. High Power Laser and Particle Beams, 2009, 21(06): 0- .
[16]	xu ming-xiu, sang feng-ting, chen fang, jin yu-qi, fang ben-jie. Effects of buffer gases on output power of COIL[J]. High Power Laser and Particle Beams, 2008, 20(11): 0- .
[17]	yan bao-zhu, yuan sheng-fu, lu qi-sheng. Starting characteristic of double-nozzle model in directly drained CW DF/HF chemical lasers[J]. High Power Laser and Particle Beams, 2008, 20(10): 0- .
[18]	xu lan, su jing-qin, peng han-sheng, jing feng, ang wen-yi, peng zhi-tao, li qiang, hu dong-xia, he shao-bo, ding lei, li ming-zhong. Output energy stability of four-pass amplification system[J]. High Power Laser and Particle Beams, 2005, 17(10): 0- .
[19]	cai guang-ming, song ying-song, yang wei-dong, zhu lian-gui, jin jing, chen rong-li. Investigation on nozzle of HF overtone chemical laser[J]. High Power Laser and Particle Beams, 2002, 14(02): 0- .